Capresso CoffeeTEC 471 Instructions d'exploitation télécharger pdf (Page 8)

1. PREPARING THE CoffeeTEC

1.1 Before First Use

a. After unpacking your CoffeeTEC

clean all the loose parts with warm

water and make yourself familar

with the different functions.

b. After reading these instructions, let

some water run through the coffee

maker to clean all internal parts.

1.2 Setting the Clock and Timer

When you plug in the CoffeeTEC the

green display will flash “AM 12:00”

and all indicator lights are off.

To set the current time:

Turn and hold the program knob to

the left (hours) to set the hours (see

fig. 2; S). While you are doing this,

watch the AM change to PM. Then

turn and hold the program knob to

the right (minutes) and set the min-

utes (see fig. 2; S).

To set the programmed time:

a. Push the program button (see fig.

2; S). The Program light (see fig. 2;

Q) will go on and the display will

show “AM 12:00.”

b. Turn and hold the program knob to

the left (hours) to set the hours.

While you are doing this, watch the

AM change to PM. Then turn and

hold the program knob to the right

(minutes) and set the minutes.

Within four seconds, the display will

revert to the current time and the

program light will turn off.

c. To change the programmed time,

push the program button (see fig. 2;

S). It will show the programmed

time. Then set the time as

described above in step b.

d. To check the programmed time,

push the program button. The

display will show the time you have

programmed to brew coffee. The

display will switch back by itself to

the current time after a few seconds.

Attention: Flashing LCD Display

(see fig. 2; L)

If you unplug the coffee maker for

more than 15 seconds or if you have

a power failure, you will lose the cur-

rent time and program settings. The

display will flash “AM 12:00” indicat-

ing that you have to reset the current

and programmed time.

1.3 Priming the frothXpress system

Before using the CoffeeTEC for the

first time to make coffee or to froth

please proceed as follows:

1. Remove water tank.

2. Fill only the lower part of the water

tank about half full (see fig. 10)

3. Replace water tank and push down

so that it engages properly.

4. Turn machine on (button P, fig 2)

5. Within 60 seconds the green Steam

Ready Light will go on (R, fig. 2).

6. Place a large cup underneath the

steam nozzle.

7. Wait approx. 30 seconds. Turn the

Steam Selector Switch (T, fig. 2) all

the way to the right - to the "Steam

On" position – until you feel resistance.

8. Allow steam to release for 30 sec.*

9. Turn the Steam Selector Switch

back to the "Steam Off" position to

stop the steam action.

10. The frother is now primed and

ready for use on a regular basis.

11. Turn the machine off (push button

P, fig, 2; the red light M will go off).

*Attention: If steaming should stop

by itself before 30 seconds are up,

turn the Steam Selector Switch back

to "Steam Off" and wait until the

green Steam Ready Light turns on

again (this will take approx. 2 minutes).

Then repeat steps (6) through (11) one

more time. The frother should now

steam without interruption for 30

seconds or longer.

8

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire